Aluminium Rear Knuckles for Stadium Blitzer and Stadium Thunder JR-TASB04-BK by Jazrider  [JR-TASB04-BK]

Aluminum Rear Knuckle Arms (Black) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
NZD$18.84
Brand:
JAZRIDER
Model:
JR-TASB04-BK
Condition:
Brand New
Available in shop
Write a review

Precision aluminium rear knuckles in black

These rear knuckle arms (model JR-TASB04-BK) are intended as a direct replacement hop-up for RC use on the Blitzer Beetle, Stadium Blitzer, and Stadium Thunder platforms. Machined from anodised aluminium and finished in black, they replace the original plastic parts to provide a firmer suspension pivot without changing the chassis geometry.

Compatibility is limited to the listed Tamiya-style Blitzer Beetle platforms only; always confirm the exact model designation before ordering. Fitment follows the vehicle's standard procedure for removing and refitting the rear knuckles. Check existing pins and screws for wear and reuse OEM hardware where suitable. The arms work with the stock hubs and steering linkages on the specified models.

In tuning terms these aluminium knuckles increase pivot stiffness compared with stock plastic, which can improve repeatability in rear steering during spirited driving. They are aimed at enhancing durability and refining setup when combined with other hop-ups and regular chassis adjustments.

No extra bespoke parts are normally required; these are designed to replace the stock rear knuckles and generally reuse the factory hubs and fasteners, but inspect hardware for wear.
The parts are made to match stock geometry so alignment should remain unchanged, though you should recheck toe and camber after fitting as part of normal setup work.
Aluminium parts resist impact and wear better than plastic, reducing the chance of knuckle failure under heavy use, but overall longevity depends on driving conditions and maintenance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved