Aluminum C-hub Carrier for Axial Yeti - Stiffer Steering YT-25001-GU by Jazrider  [YT-25001-GU]

Axial Racing Yeti Aluminum C Hub Carrier (Gunmetal)
Price:
NZD$17.96
Brand:
JAZRIDER
Model:
YT-25001-GU
Condition:
Brand New
Write a review

Heavy-duty aluminum C-hub for Yeti chassis

This gunmetal aluminum C hub carrier is an RC-scale replacement made for the Axial Yeti platform and carries model number YT-25001-GU. It replaces the stock C-hub carrier using the same mounting pattern to create a firmer link between the steering knuckle and suspension upright.

The carrier's job is to carry the steering knuckle pivot and keep wheel alignment under load. Upgrading to aluminum reduces deformation in that joint versus plastic components, helping the vehicle keep consistent steering geometry over rough ground and during aggressive cornering.

Fitting is a direct swap: remove the wheel and knuckle, unfasten the original carrier, and mount the aluminum unit with the existing hardware. Verify fastener seating and check steering movement for clearance after assembly.

Tuning advice: aluminum changes pivot stiffness, giving sharper steering feedback. Reverify toe-in and steering centring after the change to maintain stable handling balance.

How does aluminum affect durability on trail runs?

Aluminum resists wear and will not deform like plastic under heavy loads, so it helps maintain geometry after impacts and through extended use on rough trails.

Will switching to this carrier change my wheel alignment?

The part uses the same mounting points, so static alignment should match the stock set. However, reduced flex can alter dynamic alignment under load, so check toe and tracking after installation.

Does the model number YT-25001-GU indicate fitment specifics?

YT-25001-GU identifies this specific gunmetal aluminum carrier designed for compatibility with the Axial Yeti platform; use it where Yeti-compatible C-hub parts are required.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved