Yokomo YR-10F Aluminum Right Rear Bulkhead - YR-20R  [YR-20R]

Yokomo YR-20R Aluminum Rear Bulkhead(Right) for YR-10F
Price:
NZD$19.46
Brand:
Yokomo
Model:
YR-20R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YR10F category
Write a review

Aluminum Right Rear Bulkhead for the YR-10F

This replacement rear bulkhead is made for the Yokomo YR-10F formula chassis and is identified as YR-20R for the right-hand side. The component is CNC machined from aluminum, finished in black anodize with bevelled edge detail, and intended to serve as a direct-fit substitute for the original part on compatible YR-10F cars.

The bulkhead positions rear suspension and gearbox parts while adding to the chassis' rear-end stiffness and alignment. On YR-10F platforms this right-side piece preserves factory mounting locations so installation usually requires no chassis modification.

Fitment guidance: check orientation before securing, reuse factory hardware when appropriate, and tighten fasteners evenly to maintain alignment. Supplied as a single right-side unit, the part is designed for 1/10 scale formula car upkeep and setup tasks.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this bulkhead make the rear end noticeably stiffer?

Yes, replacing a stamped or plastic bulkhead with a machined aluminum YR-20R typically increases rear stiffness and can improve consistency in handling on the YR-10F.

How resistant is the black anodize to wear?

The black anodized coating offers good corrosion resistance, though track impacts and frequent handling can produce surface marks over time. Careful handling will preserve the finish.

Is this a direct replacement for the stock right bulkhead?

It is produced to match factory mounting points for the YR-10F and is intended as a direct replacement, but always compare hole placement with your chassis before installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved