Aluminum Rear Upright Hub Carrier Set for Tamiya TA07 - JR-TA703-BK by Jazrider  [JR-TA703-BK]

Tamiya TA07 Aluminum Rear Upright Hub Carriers (Black)
Price:
NZD$16.71
Brand:
JAZRIDER
Model:
JR-TA703-BK
Condition:
Brand New
Available in shop
Write a review

TA07 rear hub carrier, aluminum construction

This aluminum rear upright hub carrier serves as a direct replacement for the stock part on the Tamiya TA07 chassis. Built from machined aluminum, it gives a firmer mounting platform than typical plastic uprights, improving repeatable hub positioning.

To fit the part, remove the rear hub assembly, install the aluminum carrier using the original fasteners, and confirm bearing and axle placement. Check that suspension travel is unobstructed after installation and that wheel bearings are properly seated.

In practical setup terms the carrier reduces flex at the hub mounting point and provides a stable base for link geometry. After installation, re-check rear toe, camber, and any related roll center changes to keep the car handling as intended.

Notes: This item is provided as a mechanical spare for TA07 chassis models only. It contains no electronic components and may not be compatible with other platforms.

What sequence is recommended for installing JR-TA703-BK?

Start by removing the rear wheel and hub, note original hardware placement, press or slide out bearings if needed, then fit the new carrier and reinstall bearings and axle, checking alignment throughout.

Any quick checks to avoid binding after fitment?

Rotate the hub through full suspension travel and spin the wheel to detect rubbing; recheck bearing preload and axle play, and confirm the carrier is seated flat against the knuckle mount.

Should I replace hardware when fitting this carrier?

If original screws show wear or if the carrier requires a different shoulder or length, replace with equivalent specification fasteners. Otherwise, original hardware is typically reusable.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved