BD10 Aluminum NA Rear Suspension Front Mount - B10-301SA by Yokomo  [B10-301SA]

Front section mount for BD10 rear suspension

This separate aluminum NA-style mount is produced to sit on the front side of the rear suspension assembly of BD10 touring chassis. It replaces the original plastic mount to give a firmer datum and improved consistency when setting up suspension geometry.

Compatibility covers the BD10 chassis family listed below. The part helps lock in upper and lower mounting points at the rear, enabling small changes to roll center and arm position when combined with BD10 standard suspension pieces. In many cases the factory hardware can be reused during installation.

Function and fitment are the priorities for this part rather than cosmetic finish. Confirm fit against your BD10 rear bulkhead and check that your fasteners suit aluminium threads before tightening.

Fit this aluminum front-side rear mount to gain a stable pivot reference on BD10 variants; always pair with checked hardware and verify suspension geometry after fitment.