Anti-Roll Bar 1.3 for Medius X26 steel EP (Serpent 402195)  [SER402195]

Medius X26 anti-roll component

This Serpent 402195 anti-roll bar is a scale RC component used to adjust chassis roll characteristics on suitable 1/10 electric touring car platforms. The "1.3" marks the bar thickness and positions it as a medium-stiff option relative to slimmer or thicker sections.

Fitment is restricted to the Medius X26 steel EP family; refer to the Serpent Medius X26 steel EP (SER400052) parts listing to confirm compatibility. This item is an aftermarket spare intended to replace the original-style anti-roll bar when the mounting geometry matches.

Fitting is straightforward: attach at the suspension linkage and end-mounts that the original bar uses. Retain and reuse the existing linkage hardware where possible, and check full travel to ensure the bar does not bind after installation.

Tuning advice: moving to the 1.3 section increases roll stiffness and alters front/rear roll balance. Make incremental swaps and test each change so you can isolate handling differences during setup.