Antiroll Bar Mount for Viper 990e R, Serpent 904228  [SER904228]

Replacement Mount Details for Viper 990e R

The Serpent 904228 antiroll bar mount is an RC-scale replacement intended specifically for the Viper 990e R platform (SER904008). It secures the antiroll bar to the chassis so roll resistance can be adjusted without altering the bar itself.

Compatibility is limited to the Viper 990e R as noted in the part listing, so confirm your chassis code before ordering. This mount is manufactured to match original mounting points and to restore correct suspension geometry following wear or impact.

From a setup viewpoint, the mount affects how load is transmitted from the roll bar into the suspension system. A correctly positioned, rigid mount maintains repeatable roll stiffness and consistent handling. When you change bar diameter or end link position, inspect the mount for any play and ensure it seats correctly to avoid inconsistent results.

Installation guidance: the replacement installs at the same points as the factory unit on the Viper 990e R chassis. Check alignment throughout installation and verify that end-link angles do not bind during suspension movement. Perform handling checks at low speed after reassembly to confirm behaviour.