APC AP06030R-LH Left-Turn Propeller Replacement for RC Electric Models  [AP06030R-LH]

APC PROPELLER 6x3R-LH (3D REVERSIBLE ESC, 2 LH ROTATION)
Price:
NZD$7.72
Brand:
APC
Model:
AP06030R-LH
Condition:
Brand New
Write a review

Function and mounting notes

This APC propeller is supplied as a replacement for left-turning installations on electric RC models and similar flying platforms needing a left-hand prop. It is intended as a spare component rather than an aftermarket performance part.

Mounting guidance: check the shaft rotation direction and fit hardware securely before attempting flight. Use the motor or airframe manufacturer's guidance for spinners and retaining nuts, and always verify rotation with the power disconnected. If vibration appears likely, balance the prop prior to installation.

Tuning considerations: a propeller influences thrust, electrical load on the motor and yaw behavior; after switching to a left-hand unit observe amp draw and make measured trim adjustments during initial flights to regain the desired handling. Proceed with stepwise testing rather than large setup changes.

What bench checks should I perform before flying?

Before flight, confirm the shaft direction, check spinner and nut fit, and verify that the APC AP06030R-LH seats correctly on the hub. Do these checks with the power source isolated.

Is this suitable for reversible 3D flying and any special setup needed?

Yes, it is made for reversible 3D use; ensure the ESC settings and motor direction allow safe reversing, check current draw at low and medium throttle, and introduce full-range aerobatic maneuvers gradually.

How does changing to this prop affect motor load?

Blade geometry changes thrust and motor load. Monitor amp draw and temperature after the swap and reduce throttle or adjust the propeller choice if the motor is overloaded.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved