APC AP1107SFP Reverse/Pusher 11x7 Prop for Electric Slow Flyers  [AP1107SFP]

Reverse or Pusher Fit for Slow-Fly Models

The APC AP1107SFP prop is created for scale electric slow flyers and works in pusher layouts or reversed rotation installations where a rear-mounted reversed rotation is required. The 11x7 code identifies its diameter and pitch, helping builders pair the prop with appropriate motors and ESCs for gentle flying speeds.

Fit and compatibility: use this prop on lightweight slow-fly airframes that match the hub bore and mounting hardware. Always verify the hub bore size and the thread direction before fitting, and make sure the motor's rotation setting aligns with the chosen thrust orientation.

Installation tips: install the prop with the hub faces set for the chosen thrust, secure the retaining nut without over-tightening, and use thread locker if the model recommends it. Carry out a static balance and a slow spin test on the ground before attempting flight.

Tuning role: this prop is intended to provide dependable static thrust at lower RPM ranges for improved slow-speed handling and efficiency. If you see excess vibration or disappointing climb, check prop balance, motor timing and ESC programming, and adjust prop size only within manufacturer recommendations.