Aqueous Surfacer 500 (40ml) Water-Based Surface Primer for Plastic and Resin Models - Mr.Hobby GSI-HSF04  [GSI-HSF04]

Mr.Hobby HSF04 - Aqueous Surfacer 500 (40ml)
Price:
NZD$11.23
Brand:
Mr.Hobby
Model:
GSI-HSF04
Condition:
Brand New
Write a review

Aqueous surfacer designed for scale parts

The Mr.Hobby GSI-HSF04 Aqueous Surfacer 500 is formulated as a water-based surfacer for scale model finishing tasks. It helps level small surface defects and produces a consistent substrate for subsequent paint coats, supplied in a bench-friendly 40ml container.

Apply this surfacer when you need an even base on plastic or resin components to aid paint laydown and overall finish appearance. Ensure good ventilation and follow standard safety guidance when using modelling coatings.

Application notes: always trial the surfacer on an unobtrusive area to confirm material compatibility. Build up the coating with light, even passes rather than heavy single strokes. Once the product has set to a non-sticky state you can sand or overcoat depending on the finish you want.

Can I spray or brush the surfacer?

The surfacer can be applied with fine brushing or airbrush methods depending on dilution and user preference; always check instructions and test technique on scrap material.

How long does it take to dry before sanding?

Drying time varies with coat thickness and ambient conditions; thin coats dry faster. Wait until the surface is non-tacky before attempting light sanding.

Should I thin the surfacer for airbrushing?

If using an airbrush, test small amounts of water or recommended thinner to achieve the right viscosity, keeping in mind that over-thinning can reduce filling properties.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved