ARC A11 Lower Suspension Arm Rear (1pc) for ARC A11 O-ARCP11R by Factory Pro  [FP-O-ARCP11R]

Single rear lower suspension arm for ARC A11

This product is a single rear lower suspension arm for 1/10-scale touring cars, listed as 1pc under Factory Pro O-ARCP11R. It is intended for installation on ARC A11 chassis to replace worn parts or to adjust rear suspension geometry.

Use the arm when replacing damaged components, carrying out geometry measurements, or experimenting with handling changes. The arm sets the rear hub position relative to the chassis and affects toe, camber under load, and roll center behavior; keep these influences in mind when changing suspension components.

Fitment guidance: make sure the arm is placed in the correct orientation and mounts align before tightening, inspect nearby ball studs and fixings for wear, and recheck wheel alignment after installation. The item is sold as a single 1pc unit; confirm compatibility with your ARC A11 parts arrangement before fitting.