This aftermarket steering knuckle set is made to upgrade ARRMA Mojave 6S EXB V3 rigs, manufactured from 7075-T6 aluminum to boost rigidity and maintain accurate bearing alignment under load. The parts are designed for direct replacement of factory ARA-4289 while keeping the stock inner bearing dimension for simple hub compatibility.
Measured updates are clear: inner bearings remain 15x24x5mm, outer bearings are enlarged to 8x19x6mm (versus stock 8x16x5mm), and the knuckles feature several tie rod mount positions so you can alter steering geometry without extra machining. Hardware called out as grade 12.9 increases joint strength, and the hub nuts arrive anodized red for visual clarity.
Fitment advice: units come partially assembled for convenience, but use a medium-strength screw adhesive on suspension fasteners to reduce loosening risk in harsh environments. After fitting larger outer bearings, inspect preload and steering free-play and adjust tie rod lengths to achieve your preferred toe and Ackermann.
ARA-4289
For operators wanting improved durability and tighter bearing alignment on Mojave 6S platforms, this 7075-T6 knuckle set gives controlled changes—larger outer bearings and multiple tie rod positions—while remaining straightforward to fit on the listed ARRMA chassis.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved