ARRMA Mojave Compatible Rear Lower Mount MJ3009 for 6S EXB by GPM  [MJ3009]

Lower suspension mount description

This aftermarket rear lower suspension mount serves as an RC-scale replacement for ARRMA Mojave platforms, intended to recover or increase chassis stiffness at the rear lower pivot. It is produced as a one-piece 7075-T6 aluminium component to minimise flex and extend service life under harsh running.

The component replaces the factory rear lower mount grouping referenced in the source documentation and ships with the mounting fasteners indicated below. Its main purpose is structural and tuning-focused: limiting play at the lower suspension pivot keeps geometry steadier when the vehicle is loaded, affecting handling and tyre traction on loose surfaces.

Fitment notes: installation uses the Mojave rear end's existing attachment points. Disassemble the original assembly carefully, reuse bearings and pins if appropriate, and tighten screws in stages to prevent stripping the aluminium threads.

For NZ builders running ARRMA Mojave 6S variants, this 7075-T6 rear lower suspension mount MJ3009 is a durable direct-replacement designed to tighten rear-end behaviour and keep suspension geometry consistent during off-road use.