Arrowmax AM-150279 5/16' Nut Driver 100mm Shaft - Hollow Anodised Handle  [AM-150279]

Arrowmax AM-150279 Nut Driver 5/16' (7.938MM) X 100mm
Price:
NZD$25.52
Brand:
Arrowmax
Model:
AM-150279
Condition:
Brand New
Write a review

RC Workshop Driver: Arrowmax AM-150279

The Arrowmax AM-150279 nut driver delivers precise handling for RC assembly and repairs. Its 5/16" (7.938MM) tip and 100mm shaft are sized to reach recessed nuts while keeping good leverage.

Hollow Anodised Aluminium Grip

A hollow aluminium grip finished in purple lowers the tool mass and improves hand traction, letting you work comfortably during longer builds or race prep.

High-Strength Tip for Consistent Fit

The tip is machined from special spring steel to withstand twisting forces and keep a tight interface with fasteners under repeated use.

Smooth Palm-Rotate End Caps

Rotating aluminium end caps enable precise palm control for gradual torque application and minor tune ups without slipping.

Can this reach lug nuts in tight wheel wells?

The 100mm shaft helps access nuts in recessed areas. For very deep wells a longer shaft may be needed, but this driver covers many standard applications.

Will the anodised finish chip with heavy use?

Anodising adds surface durability but can show wear if knocked or scraped repeatedly. Treat the tool as part of your kit and avoid dropping it onto hard surfaces.

Is this suited for both on-road and off-road models?

Yes. The robust tip and ergonomic handle make it useful across on-road and off-road RC models where the 5/16" size is used.

How do I clean the tip after track use?

Wipe the tip with a clean cloth and use light oil if any corrosion appears. Avoid abrasive cleaners that could alter the tip profile.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved