Arrowmax AM-348016 48P 16T 7075 Hard-Anodised Pinion  [AM-348016]

Arrowmax AM-348016 Pinion Gear 48P 16T 7075 Hard
Price:
NZD$8.94
Brand:
Arrowmax
Model:
AM-348016
Condition:
Brand New
Write a review

Precision Drive with Arrowmax AM-348016

The Arrowmax AM-348016 pinion delivers precise engagement for a range of RC drivetrains. Constructed from 7075 aluminium, it combines rigidity and low mass for dependable tooth mesh under load.

What Makes 7075 Aluminium Stand Out

7075 aluminium is chosen for parts that must resist deformation while staying light. For pinions this means reduced flex at high rpm and improved resistance to wear compared with softer alloys.

Model Compatibility and Use

As a 48P 16T unit, this pinion suits many standard gearboxes and motor setups. It is a versatile choice for both on-track and mixed-surface running where consistent gear engagement matters.

Will this pinion work with nitro and electric cars?

Yes. The 48P 16T form factor suits both electric and nitro drivetrains as long as the gearbox accepts 48-pitch gears.

Is any special tooling required to fit this pinion?

Standard pinion fitting tools and an accurate motor shaft aligner are sufficient. Ensure the grub screw torque is correct to avoid shaft damage.

Should I match this with a specific spur gear tooth count?

Choose a spur that achieves your target gear ratio for track conditions. The 16T pinion gives a good balance of acceleration and top speed with common spur sizes.

How do I inspect the gear after a heavy crash?

Check each tooth for chips or bending and spin the gear to feel for wobble. Replace if teeth are deformed or the bore is damaged.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved