Arrowmax AM-348087 48P 87T Spur Gear - Track Ready  [AM-348087]

Arrowmax AM-348087 Spur Gear 48P 87T
Price:
NZD$6.51
Brand:
Arrowmax
Model:
AM-348087
Condition:
Brand New
Write a review

Precision Spur Gear for RC Models

The Arrowmax AM-348087 48P 87T spur gear is engineered to give accurate power transfer and dependable tooth contact for model builders. It performs well in setups where consistent mesh matters for lap times or everyday reliability.

Designed for Balanced Performance

This 48-pitch, 87-tooth spur offers a balanced compromise between torque and top speed suitable for both racing layouts and general running. Its tooth profile helps ensure smooth engagement in compatible gearboxes.

Quality Manufacture for Longer Service

Produced by Arrowmax, the gear benefits from careful finishing to reduce premature wear. Its compatibility with many RC car platforms makes it a flexible option when upgrading or replacing spur gears.

How do I confirm this spur will fit my car?

Measure your existing spur's pitch and tooth count and compare bore and face width. If your model uses 48P and accepts an 87T spur, the AM-348087 should fit.

Can this gear be used in both electric and nitro setups?

Yes, where the transmission uses a 48P spur arrangement it can be used with either power source. Ensure cooling and mesh are correct under high RPM or load.

Is break-in required for this Arrowmax spur gear?

Minimal break-in is needed. Fit with correct mesh, run at low loads for a few sessions, and re-check mesh and fasteners before pushing hard.

What pinion choices work well with an 87T spur?

Pinion selection depends on desired gear ratio and motor characteristics. Use small increments to change speed or acceleration and check temperature and current after each change.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved