Arrowmax AM-364063 64P 63T 7075 Alloy Pinion - Lightweight Strength  [AM-364063]

Arrowmax AM-364063 Pinion Gear 64P 63T 7075 Hard
Price:
NZD$13.01
Brand:
Arrowmax
Model:
AM-364063
Condition:
Brand New
Write a review

Engineered 64P 63T Pinion by Arrowmax

Arrowmax AM-364063 brings a finely machined 64P 63T pinion option for modellers seeking consistent gear engagement. Constructed from 7075 aluminum, it delivers a good mix of stiffness and low mass to support accurate tuning of your model.

Why 7075 Works Well for Pinions

7075 alloy is chosen for parts that need toughness without unnecessary bulk. The material reduces flex under load, helping the pinion retain its tooth profile under repeated runs and adjustments.

Fits Many 64 Pitch Setups

This 63 tooth pinion suits a variety of 64 pitch gear trains, allowing hobbyists to change ratios cleanly when chasing different acceleration or top speed characteristics.

Will the Arrowmax AM-364063 fit my 1/10 buggy?

If your buggy uses 64 pitch gears, the 63T count should be compatible. Always check shaft diameter and bore fit before final installation.

Is this pinion suitable for off-road use?

Yes, the 7075 alloy construction is resilient enough for typical off-road conditions, though you should avoid heavy impacts and keep the drivetrain free of grit.

What is the best way to check gear mesh?

Use a pencil or grease to mark the mesh, adjust the pinion position until contact is even along the tooth face, then lock the pinion and recheck after a short run.

How often should I inspect the pinion for wear?

Inspect the pinion after high-use sessions or if you notice changes in drivetrain noise or performance; frequency depends on terrain and driving style.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved