Arrowmax AM-490037-LE 2.0 x 70mm Arm Reamer - Limited Edition  [AM-490037-LE]

Price:
NZD$41.34
Brand:
Arrowmax
Model:
AM-490037-LE
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tool overview for arm and link bores

The Arrowmax AM-490037-LE Arm Reamer 2.0 x 70mm Limited Edition serves as a cleanup and sizing tool for RC suspension arm holes and linkage bores. The tool's 2.0mm cutting diameter and 70mm length suit the common hinge-pin and link sizes used on 1/10-scale and similar electric touring and off-road rigs.

During assembly and setup, the reamer helps ensure holes are concentric and free of burrs so the linkage moves smoothly. It can square up drilled openings and produce a repeatable bore diameter before you install pins and bearings.

For best results, use a low-speed pin vise or hand tool, align the cutter carefully with the existing hole, and remove material with gentle passes. Excessive pressure can oversize the hole, so proceed incrementally and check fit often.

Product specifications

  • Item: Arrowmax AM-490037-LE Arm Reamer 2.0 x 70mm Limited Edition
  • Model Number: AM-490037-LE
  • Size: 2.0 x 70mm
  • Material: Not specified
  • Compatibility: For RC suspension arm holes and link rods (general use)

A useful precision tool for hobbyists who want consistent hinge-pin bores; pair it with careful measuring and test fitting to lock in correct clearances.

What length of reach does this reamer offer?

The reamer has a 70mm length, providing extended reach for deeper link rods or when working through thicker arm sections common on some 1/10 scale setups.

Can I expect long tool life?

Longevity depends on work material and technique; using light passes and avoiding hard impacts will preserve the cutting edge. The listing does not specify blade material, so treat it as a precision hand tool.

Will it produce a clean finish on plastic arms?

Yes, with controlled, slow cuts the reamer will remove burrs and leave a truer bore in most plastics. For delicate plastics go slowly and test fit frequently to avoid overcutting.

Is special equipment required to use this tool?

No special machinery is required; a pin vise or low-speed hand holder is sufficient. Keep the tool steady and aligned, and work in small increments to maintain control.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved