Arrowmax AM-700706 AM Lipo 6200mAh 2S Low Profile 7.4V Graphene Pro Pack  [AM-700706]

Arrowmax AM-700706 AM Lipo 6200mAh 2S TC Low Profile - 7.4V 65C Continuos 130C Burst (Graphene Pro)
Price:
NZD$143.94
Brand:
Arrowmax
Model:
AM-700706
Write a review

6200mAh low-profile 2S pack tailored for on-road rigs

This Arrowmax AM-700706 2S LiPo is a low-profile, Graphene-enhanced battery designed for RC-scale on-road touring and stock-class use. The pack is specified at 6200mAh with a 7.4V nominal voltage and rated 65C continuous with 130C burst, delivering a low internal resistance and a stable voltage under load to support consistent motor response.

Its compact casing suits contemporary low-centre-of-gravity chassis and helps keep weight distribution predictable. Check physical clearances and lead routing on your particular 1/10 touring bay to avoid interference with steering or suspension travel.

For set-up, place the pack centrally and low, fasten it securely, and keep cables away from fans and moving components. The pack supports conservative tuning and gearing for stock-class racing, where steady voltage and low sag improve lap-to-lap consistency.

Specifications

  • Item: LiPo battery pack
  • Capacity: 6200mAh
  • Voltage: 7.4V (2S)
  • C Rating: 65C continuous, 130C burst
  • Dimensions: 139 x 47 x 25 mm
  • Weight: 288 g
  • Material: Graphene Pro cells
  • Model Number: AM-700706
  • Compatibility: Intended for 1/10 touring and stock-class on-road platforms

Ideal for drivers wanting a low-profile 2S pack that maintains voltage under load; always follow LiPo charging, transport, and storage best practices.

What run time should I expect from a 6200mAh 2S in touring use?

Run time varies with motor, gearing, and driving style; expect longer sessions with conservative gearing and moderate throttle. Use a wattmeter to measure typical draw for an accurate estimate.

How can I monitor internal resistance or cell health?

Use a charger with internal resistance or cell check functions, or a dedicated IR meter, and compare readings over time to track degradation.

Any tips for fitting into tight low-profile bays?

Measure pack dimensions against the bay, remove unnecessary foam or brackets if safe, and plan cable routing before securing the battery to avoid pinches or pressure points.

Does Graphene Pro change charge procedures?

Charging is the same as standard LiPo chemistry: use a suitable 2S LiPo program and balance charge. Graphene cells improve discharge stability but do not require special charge voltages.

How can I minimise voltage sag during long runs?

Keep connections short and thick, ensure good solder joints, use correct gearing, and avoid excessive throttle peaks to reduce sag; the AM-700706's low internal resistance helps here.

Are there transport or shipping considerations for this pack?

Follow local and airline rules for LiPo transport: store at safe voltage, protect terminals, and declare batteries when required. Check carrier regulations before travelling with packs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved