Mugen MTX-5 Steel Clutch Bell Arrowmax AM-MTX5-T2706 - Race Grade  [AM-MTX5-T2706]

Arrowmax AM-MTX5-T2706 Clutch Bell (steel)
Price:
NZD$23.80
Brand:
Arrowmax
Model:
AM-MTX5-T2706
Condition:
Brand New
Write a review

Precision Steel Clutch Bell for the Mugen MTX-5

The Arrowmax AM-MTX5-T2706 is a purpose made clutch bell for the Mugen MTX-5 platform, engineered from hardened steel for extended life. It gives a robust replacement option for hobbyists who demand steady drivetrain behaviour. The construction aims to reduce deformation and maintain consistent engagement session after session.

Why Choose Steel for the Clutch Bell?

Steel delivers clear benefits in resistance to wear and heat compared with softer alloys. Using the Arrowmax AM-MTX5-T2706 helps keep the Mugen MTX-5 running predictably under braking and full throttle, which is important for tuning and repeatable lap times.

Straightforward Fitment on MTX-5 Cars

Designed around the Mugen MTX-5 geometry, this Arrowmax clutch bell fits with minimal fuss. The accurate sizing speeds up installation so you can get back to setup and track time without complex modifications.

Can I reuse my existing clutch shoes with this bell?

Yes, you can reuse shoes if they are in good condition. Inspect for glazing and uneven wear and replace if necessary to ensure proper contact with the new steel bell.

Is any break in required for Arrowmax AM-MTX5-T2706?

A short bedding in under light running helps the clutch shoes match the bell surface. Do a few low load runs before pushing hard to stabilise engagement.

Will the steel bell affect gear wear?

Proper alignment is key. If installed correctly the steel bell should not increase gear wear, but misalignment can accelerate wear on mating components.

What tools do I need to fit this part?

Basic hand tools, a torque driver and a small file for light deburring are usually enough. Confirm shaft fit and secure fasteners to the recommended torque.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved