Arrowmax MTX-T2708 14-Tooth Racing Gear for Mugen MTX-5 [AM-MTX-T2708]

Arrowmax AM-MTX-T2708 1st. Gear 14T (7075 HARD)

Price:

NZD$11.02

Brand:

Arrowmax

Model:

AM-MTX-T2708

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Arrowmax MTX-T2708 14T Gear Built for Consistent Engagement

The Arrowmax MTX-T2708 1st Gear is produced from 7075 aluminium to offer the Mugen MTX-5 a resilient, low-mass replacement. The 14-tooth design aims to reduce drivetrain play and provide steady torque transfer during extended runs.

Precision Machining for Reliable Mesh

Specifically matched to the Mugen MTX-5, this gear features precisely cut teeth to promote even contact and reduced wear. The high-strength 7075 aluminium helps keep rotational mass low for better throttle response.

Why This Gear Works

Material: 7075 aluminium for excellent strength-to-weight performance.
Compatibility: Engineered to fit the Mugen MTX-5 without modification in normal setups.
Durability: Improved tooth profile reduces long term wear under racing loads.

Can this gear be used with aftermarket pinions?

Yes, it works with common aftermarket pinions that match the MTX-5 spacing, but always verify mesh and alignment after installation.

Will this change my final drive ratio?

No, the tooth count stays at 14 so the ratio is unchanged; the benefit is improved durability and cleaner engagement rather than gearing changes.

How long should I expect it to last?

Lifespan depends on use and maintenance, but 7075 aluminium typically outlasts standard alloys when mesh is properly set and the drivetrain is kept clean.

Any setup tips for race trim?

After fitting, perform a short break-in run, then recheck mesh and tighten mounting hardware to recommended torque to avoid movement under load.