Associated RC18T 56T Delrin Spur Gear - DAR056T by GPM  [DAR056T]

Associated RC 18T Delrin Main Gear (56T) - 1pc - GPM DAR056T
Price:
NZD$11.14
Brand:
GPM
Model:
DAR056T
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement 56T spur for Associated RC18T

This 56-tooth Delrin main gear is supplied as 1 pc and serves as an aftermarket replacement compatible with Associated RC18T models. It installs in the standard spur carrier and keeps the original motor mounting alignment intact.

Acetal Delrin combines lower friction with good wear resistance compared with basic moulded plastics, helping the gear hold a stable mesh under typical 1/18 electric off-road loads. It is suitable for regular hobby running where a precise tooth profile and low drag are useful.

Installation tips: check pinion and spur teeth for wear before fitting, set backlash using the paper shim method, and verify there is no binding across the gearbox and suspension travel. This gear is intended for maintenance replacement or evaluation during tuning runs.

Is bore sizing standard for Associated RC18T spurs?

The part is produced for Associated RC18T fit; confirm your existing spur bore and centre distance match before assembly to ensure correct fitment.

How do I check mesh under load?

After initial mesh set with paper, run the motor at low throttle and watch for tight spots or chatter, then adjust pinion location or backlash as required.

Will Delrin handle frequent club running?

Delrin offers a good balance for routine club running, showing predictable wear and lower drag; heavier or extreme use may still favour metal or reinforced options.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved