Auper D6 Compatible Aluminum Motor Mount Base A SAK-D6808F/BU by 3Racing  [SAK-D6808F/BU]

3RACING Auper D6 Aluminum Motor Mount Base A Blue - SAK-D6808F/BU
Price:
NZD$9.60
Brand:
3Racing
Model:
SAK-D6808F/BU
Condition:
Brand New
Write a review

Precision Aluminium Mount A for the Auper D6

This machined aluminum mount base is crafted for the Auper D6 1/10 electric on-road chassis, providing secure motor fastening and fine adjustment of fore-aft and rotational position so the pinion meshes cleanly with the spur.

Installation notes: fit the piece to the Auper D6 motor block locations using the chassis' designated fasteners; set the motor shaft on the spur centreline and check mesh before final clamp-down to reduce gear and bearing wear.

Tuning role: a stable aluminum platform makes setup changes repeatable, helping maintain the same gear mesh and dependable torque transfer during tuning and component swaps.

Is this more robust than the stock mount?

Compared with many plastic mounts, a machined aluminum base offers superior rigidity and resistance to deformation, which helps keep mesh stable under sustained load.

Will it reduce drivetrain slop?

By providing a firmer mounting reference, the aluminum base can reduce movement at the motor interface and minimise mesh variation, though final results depend on the entire drivetrain setup.

Any special prep before fitting?

Clean mating faces, check fastener lengths, and ensure threads and inserts are in good condition; set mesh with care and then torque evenly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved