Auper D6 Rear Belt Pass Plate SAK-D6808A/BU for Blue Finish by 3Racing  [SAK-D6808A/BU]

Blue machined rear belt plate compatible with Auper D6

This machined aluminium rear bulkhead belt plate has been produced as a scale replacement for the Auper D6 chassis. It sits at the rear bulkhead to guide belt routing and presents a firmer interface where the belt crosses, helping to keep alignment under throttle and braking loads.

The item is intended for Auper D6 layouts that employ a rear bulkhead belt arrangement. Supplied in a blue finish, it functions as a direct-fit hop-up where the original belt plate can be removed or serviced within the kit design.

Fitting typically follows the kit access routine to the rear bulkhead and uses the chassis' existing mounting points; consult your Auper D6 instruction sheet for fastener positions and recommended torque. As a durability upgrade, the aluminium plate helps limit flex at the belt pass and supports repeatable drivetrain characteristics over time.

Fit this machined aluminum rear bulkhead belt when you want a tougher, more repeatable belt pass on Auper D6 kits that benefits durability and serviceability.