Auper D6 Titanium Steering Rack Bolt Replacement SAK-D6805A by 3Racing  [SAK-D6805A]

Overview: titanium steering bolt for Auper D6

The SAK-D6805A is a steering rack bolt sized for the Auper D6 chassis and intended as a direct replacement part. It secures the steering linkage and helps preserve factory steering geometry while allowing careful play adjustments.

Titanium offers lower weight and good resistance to corrosion compared with standard steel bolts, which helps reduce routine wear in damp or coastal running conditions. The bolt is intended to interface with the stock steering rack and associated linkages on the Auper D6.

For installation, follow the chassis service procedure, move over any bearings or spacers, slide the SAK-D6805A into position and tighten to the recommended torque. After reassembly, verify full steering travel and make micro adjustments at the servo saver or turnbuckles to fine tune response.

Use case: ideal for replacing a degraded fastener or upgrading to a material that reduces long term corrosion and maintains consistent steering contact points for repeatable setup work.