Auper D6 Turnbuckle and Ball End Upgrade SAK-D6807D by 3Racing  [SAK-D6807D]

Service and fine adjustment components

This 3Racing SAK-D6807D set supplies ball ends and steel turnbuckles intended for use on the Auper D6 RC chassis, serving as direct replacement components for steering and suspension linkage points.

The hardened steel turnbuckles offer a stable threaded connection for toe and camber rods, while the ball ends deliver smooth articulation to reduce binding during suspension travel. Replace worn link components to restore predictable movement and setup repeatability.

To install, detach the old ball end or turnbuckle, push the new ball end onto the linkage rod or servo horn, then thread the turnbuckle in until the desired length is reached. Verify full thread engagement and any locking method to avoid slippage during operation.

Tuning tip: make measured, single changes to turnbuckle length to assess how toe and camber adjustments affect cornering balance before progressing further.