Awesomatix A12X 2.0mm Graphite Servo Mount O-ACPP02 by Factory Pro  [FP-O-ACPP02]

Price:
NZD$20.99
Brand:
Factory Pro
Model:
FP-O-ACPP02
Condition:
Brand New
Write a review

Steering precision upgrade for A12X chassis

This aftermarket servo plate is made for the Awesomatix A12X and is supplied by Factory Pro under model O-ACPP02. The 2.0mm graphite construction provides a stiffer mounting plane that helps maintain accurate transfer from the servo to the steering linkage on 1/12 scale touring cars.

Fitment is intended to match the A12X mounting layout so no chassis cutting is normally required. Install using the stock mounting holes and hardware where possible, then check centre position and travel while trimming endpoints on your transmitter as needed. The plate supports the typical servo positions used in A12X tuning setups.

For tuning the graphite plate reduces flex at the servo mount, which makes small steering adjustments more repeatable and assists when dialing in steering response on track.

How does 2.0mm graphite affect steering sensitivity?

The thicker graphite reduces mounting flex, which typically makes steering feel crisper and more consistent, helping you feel subtle changes when adjusting trims and end points.

Will this plate change the servo centroid or require rebalancing?

The plate is lightweight and usually does not alter vehicle balance significantly. Recheck trim and steering endpoints after installation, but full rebalance is rarely necessary.

Can different servo horns or lengths be used with this plate?

Yes. The plate accepts common horn positions used on A12X setups; choose horn length to suit your steering geometry and verify clearance and travel.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved