This threaded aluminum tube is intended as a replacement part for AXIAL AX10 Scorpion chassis assemblies in scale crawler builds. It provides the correct 6 x 101-A30 threaded interface where specified on the chassis.
As a direct replacement component, the tube installs into the existing AX10 Scorpion mounting points and supports link attachments and fasteners. Its purpose is structural, delivering a reliable threaded surface to keep joints tight and chassis geometry consistent after service or upgrades. Additional fixings are not included, so inspect your chassis layout to confirm compatibility prior to installation.
Fitting advice: thread the tube fully into the matching AX10 Scorpion location, ensure correct engagement and alignment, and check that moving parts clear the tube through full travel. This part is aimed at scale RC crawler maintenance and setup tasks.
Fit this tube to replace damaged threaded tubing on AX10 Scorpion frames and restore secure mounting for links and fasteners during trail use.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
