AX10 Scorpion Servo Mounting Post AX10-26/SI by 3Racing  [AX10-26/SI]

AXIAL AX10 Scorpion Chassis Servo Post - 3RACING AX10-26/SI
Price:
NZD$6.51
Brand:
3Racing
Model:
AX10-26/SI
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Servo Mount for AX10 Scorpion

This servo post serves as a replacement mounting point for the AX10 Scorpion chassis family and is made for direct-fit installation into AX10 kits without altering the intended servo link geometry.

Functionally it positions the servo inside the chassis, keeps the steering linkage aligned and provides a secure fixing point under steering loads. When fitting the post, check hole alignment with the chassis and ensure the servo horn clears surrounding parts over the full travel range before final tightening.

During setup use the mounting position to refine servo height and linkage angles instead of relying solely on different servo arm lengths. Small adjustments at the mount can tweak steering centring and end-point behaviour, so test travel through suspension articulation after installation.

Is this a straight swap for AX10 kits?

Yes, the post is intended as a straight replacement for AX10 Scorpion chassis mounts, though you should confirm the exact mounting hole pattern on your kit.

What clearance checks should I do?

Fit the post and servo loosely, then cycle the steering to verify the horn and linkage do not contact chassis or suspension parts at full lock and through travel.

Does this require servo reprogramming?

No electronic changes are needed for most installs; you may need to fine-tune centring and end-points in your transmitter after mechanical fitment to match the new mounting height or angle.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved