AX10 Scorpion Threaded Turnbuckle M6x55 Link AX10-21/GR by 3Racing  [AX10-21/GR]

This M6x55 turnbuckle is intended for use on the AX10 Scorpion chassis and is catalogued as part AX10-21/GR. The component is a straight threaded rod used to tune or replace steering and suspension links on scale crawler builds based on the AX10 Scorpion platform.

Functionally the turnbuckle gives precise length control so you can fine-tune toe, caster and ride height without swapping other parts. Use it wherever a threaded M6x55 link is needed to set geometry or to repair a damaged factory link; confirm thread form and overall length before installation to ensure correct engagement with your connectors.

Fitting advice: engage the M6x55 rod into corresponding rod ends or ball studs until secure, adjust both sides evenly, and inspect alignment under static load before running. Make measured adjustments to dial in steering response while maintaining safe thread engagement.