Axial 1/6 SCX6 Rear Suspension Tower Aluminum Fitment - JR-SCX604-TI by Jazrider  [JR-SCX604-TI]

Mounting and Design Notes

Designed for Axial 1/6 SCX6 Jeep platforms, this aluminum rear shock tower carries the model number JR-SCX604-TI and serves as an RC-scale upgrade. It replaces the original tower to provide a more rigid mounting location that helps maintain consistent shock alignment on rough trails.

The listing describes the set as an aluminum rear shock tower with the designation "Titianum". It is presented as a scale replacement intended to interface with SCX6 rear suspension geometry and not for use on any full-size vehicle.

Installation guidance: the unit is intended to replace the factory rear shock tower. Fitting usually requires common hand tools to remove the standard tower and install the replacement; verify screw lengths and thread engagement before final tightening. Use the SCX6 chassis mounting points when placing the tower.

Use this aluminum rear shock tower set when you require a tougher, more stable rear shock mounting solution for scale trail rigs on Axial SCX6 models, and confirm compatibility and fastener lengths prior to final torque.