AXIAL AX10 Scorpion Driveshaft End Cap AX10-10 Upgrade by 3Racing  [AX10-10]

AXIAL AX10 Scorpion Scorpion Driveshaft Cap - 3RACING AX10-10
Price:
NZD$19.20
Brand:
3Racing
Model:
AX10-10
Condition:
Brand New
Write a review

Cap Description for AX10 Scorpion

This driveshaft end cap is made for the AXIAL AX10 Scorpion and carries the AX10-10 model code. It locates and holds the driveshaft interface without altering the original axle layout.

The component locks the driveshaft terminus and helps maintain correct alignment between shaft and axle housing while the model is in use. It is designed as a direct-fit so existing mounts and screws can be reused when suitable.

Replacing a damaged cap can recover consistent seating and reduce driveline lash that affects handling. Inspect splines and adjacent bearing surfaces during service to ensure smooth rotation after reassembly.

Does this suit modified AX10 shafts?

It fits standard AX10 Scorpion axle ends. If you have custom-length or nonstandard shafts, measure mounting locations before fitting.

Material concerns for heavy use?

Check the seller's listing for material details. For aggressive driving, confirm the cap and surrounding hardware are in good condition to avoid premature wear.

Simple fitment checklist?

Clean mating surfaces, align the cap to the driveshaft end, hand-tighten fasteners, then verify free rotation before final torqueing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved