AXIAL AX10 Scorpion Mount Plate Graphite Battery Radio Tray AX10-20/WO by 3Racing  [AX10-20/WO]

AXIAL AX10 Scorpion Chassis Graphite Battery Radio Tray Plate - 3RACING AX10-20/WO
Price:
NZD$20.95
Brand:
3Racing
Model:
AX10-20/WO
Condition:
Brand New
Write a review

Graphite mount for AX10 Scorpion

This is a graphite battery and radio tray made to fit the AXIAL AX10 Scorpion chassis, listed as model AX10-20/WO. It holds battery packs and the receiver assembly securely while allowing neat cable runs inside the chassis bay.

As an upgrade or replacement tray, the graphite material delivers reduced flex over many plastic trays and helps maintain consistent component placement through tuning and running. It works with standard receiver and battery setups used in AX10 builds.

Installation: the tray matches factory AX10 screw points so you can usually swap over existing fasteners. Check clearance around battery straps and connectors and confirm antenna position before tightening.

Setup benefits: a stiffer tray makes it easier to experiment with battery position and weight distribution without the tray deforming, helping maintain predictable handling when you change pack sizes.

Maintenance: keep the tray free of grit, use a soft cloth for cleaning and inspect screw bosses to prevent loosening during rough use.

Is this a direct replacement for the stock tray?

Yes, it is cut to fit the AX10 mounting layout so it acts as a direct replacement in most builds.

Do I need different screws to fit it?

In most cases the original screws are suitable, but check thread engagement and replace any stripped hardware to ensure a secure fit.

Will this change vehicle handling?

A stiffer tray reduces battery movement and can make weight distribution more predictable, which may slightly alter handling when compared with a more flexible plastic tray.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved