Axial Racing AX10 Deadbolt Body Mount Post, Precision Aluminum - AX10-24023-BK by Jazrider  [AX10-24023-BK]

Axial Racing AX10 Deadbolt Aluminum Body Post
Price:
NZD$14.38
Brand:
JAZRIDER
Model:
AX10-24023-BK
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement aluminum body post for AX10 Deadbolt

This aluminum body post is an aftermarket replacement intended for use with the Axial Racing AX10 Deadbolt chassis. It creates a stable interface between the polycarbonate body and the AX10 Deadbolt frame, with a black finish to match common body shells and provide a neat appearance.

Use this post to swap out worn plastic mounts when you need better rigidity or repeatable body positioning for clearance or competition setup. It installs at the original AX10 Deadbolt mounting points and helps maintain consistent body height through repeated use.

Fitting advice: align the body holes to the AX10 Deadbolt post before tightening, use typical hand tools such as an Allen driver for screws, and test clip retention after installation to ensure correct spacing.

How do I check fitment on my AX10 Deadbolt?

Place the post into the AX10 Deadbolt body hole and confirm it lines up with the chassis mounting point. If aligned, the post will sit flush and accept standard body clips.

Will this change body clearance or stance?

The post itself is intended to match factory mounting height; use it to fine-tune body clearance by adjusting clip positions rather than changing chassis geometry.

Does installing the post require replacements fasteners?

In most cases the stock fasteners or the hardware supplied with the body will work. Keep a hex driver handy to tighten screws to a snug fit.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved