JAZRIDER ASCX10-22403-02-GR Offroad Steering Linkage for Axial SCX-10 Honcho and Dingo  [ASCX10-22403-02-GR]

Axial Racing SCX-10 Honcho & Dingo Aluminum Steering Linkage (Green)
Price:
NZD$11.99
Brand:
JAZRIDER
Model:
ASCX10-22403-02-GR
Condition:
Brand New
Write a review

Stiffer Aluminum Linkage for Offroad Runs

Hobbyists wanting a tougher steering setup for their Axial SCX-10 Honcho or Dingo will find the JAZRIDER aluminum linkage a useful swap. It replaces the weaker plastic rod with a green-anodized aluminum piece that sharpens steering response and stands up to rough tracks.

Advantages of an Aluminum Upgrade

Switching to aluminum reduces flex and wear compared with the stock plastic component, keeping steering geometry more stable under stress. That stability helps when pulling precise inputs over chunky terrain and technical sections.

Installation Tips and Compatibility

The JAZRIDER unit fits into the SCX-10 Honcho and Dingo layouts without major changes. Installation is straightforward for most modders and requires only standard tools and a basic alignment check after fitting.

Is any fabrication required to fit this linkage?

No fabrication is normally required. The part is designed to replace the stock linkage and uses the existing mounting points.

Will this change my steering throw or geometry?

The linkage keeps the original geometry when installed correctly, so steering throw should remain consistent while benefiting from reduced flex.

How should I maintain the aluminum linkage?

Rinse off grit and inspect for bends or stripped threads after hard sessions. The anodize helps protect the surface but clean assembly and occasional checks will extend service life.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved