This aluminium rear guard with a built-in spring is a purpose-made replacement for AXIAL Racing SCX10 II vehicles, supplied as one set for hobby assembly. The design pairs a rigid aluminium mounting plate with a spring element to allow measured deflection during minor impacts, helping maintain chassis alignment and secure rear accessory mounts on rough trails.
Installation uses the SCX10 II stock rear mounting points and common fasteners, and the part is intended as a reinforcement rather than a crush-zone bumper. The spring reduces direct shock transfer while the aluminium body resists bending compared to OEM plastic components.
When tuning, adjust spring preload and check clearances around rear accessories to achieve the desired mix of protection and axle articulation without modifying electronics or suspension geometry.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved