A spare front and rear main drive shaft set created for use with the AXIAL Racing SCX10 scale crawler. The design blends steel for critical load zones with aluminium where lower rotating weight benefits the drivetrain response.
The set supports the listed center-to-center ranges and is sold as an SCX10-compatible upgrade: front 117mm-127mm and rear 122mm-132mm. Always measure your axle-to-gearbox distances before fitting to confirm compatibility with your frame and axle arrangement.
Installation guidance: service bearings and hex adapters before fitting, verify spline fit with spur and axle gears, and tighten fasteners to the torque values recommended by your chassis maker. These shafts are for restoring or improving driveline geometry and durability, not for radically changing vehicle handling.
Ideal for replacing worn drive components or adjusting driveline length on SCX10 rigs; double-check measurements and alignment after installation.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
