JAZRIDER JR-SCX2401-HD Brass Front Knuckle Set for Axial Racing SCX24  [JR-SCX2401-HD]

Axial Racing SCX24 Brass Front Steering Knuckle Set
Price:
NZD$14.56
Brand:
JAZRIDER
Model:
JR-SCX2401-HD
Condition:
Brand New
Available in warehouse
Write a review

Sharpen Steering for Technical Lines

For drivers wanting steadier steering on an Axial Racing SCX24, the JAZRIDER JR-SCX2401-HD brass front steering knuckle set gives a straightforward performance bump. Made for the 1/24 scale SCX24, it enhances front-end composure when tackling rough ground.

Why Brass Improves Handling

Brass adds both robustness and useful front-end mass, which improves contact patch behaviour and steering response on the SCX24. The added weight helps the front wheels stay planted, aiding cornering and slow-speed control.

Installation Notes and Fit

Fitting the JAZRIDER brass knuckles is a simple swap for the factory plastic parts and does not require specialised tools. They are a direct fit for the SCX24 platform, allowing hobbyists to upgrade handling without extensive modification.

Is model JR-SCX2401-HD compatible with older SCX24 kits?

In most cases yes. The brass set is intended to match the original steering knuckle geometry used across common SCX24 releases.

Will corrosion be an issue with brass parts?

Brass is corrosion resistant but occasional cleaning and light lubricant will keep pivots moving smoothly over time.

Should I re-setup my suspension after fitting?

It is a good idea to check ride height and steering trim after installation, since the extra front weight can change handling balance slightly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved