AXIAL Racing SMT10 Wheel Hex +2mm Offset, Aluminium - MJ0102/+2MM by GPM  [MJ0102/+2MM]

SMT10 aluminium wheel hex for tuning

This aluminium wheel hex is intended for use with AXIAL Racing SMT10 model chassis and is supplied as a pair with a +2mm offset to change track width while leaving wheel backspacing unchanged. It suits hobby model use where small stance adjustments are needed.

Role and benefits: the hex shifts wheel mounting position to allow fine tuning of track and clearance. Machined aluminium construction gives stronger wheel retention than plastic hexes and helps preserve wheel alignment under driving loads.

Fitting advice: remove the stock hex and fit these aluminium units using the existing axle and wheel hardware on your SMT10. Confirm tyre and suspension clearance after adding a +2mm offset, tighten by hand first then apply your normal wheel torque. Not for use on real vehicles.

Included hardware: the package supplies the wheel hexes plus the small fitting parts commonly needed during installation, listed here for clarity: 2pcs wheel hex, 2x10.9 steel pin - 2pcs, 2x7 steel pin - 2pcs, 2.5x2.5 screw shaft - 4pcs, 1.2 hex socket key - 1pc.