Axial Racing Wraith Aluminum Hex Hub Upgrade for Improved Track Width - AW-23025-GR by Jazrider  [AW-23025-GR]

Axial Racing Wraith Aluminum Hex. Wheel Hub / 5mm Wider (Green)
Price:
NZD$5.18
Brand:
JAZRIDER
Model:
AW-23025-GR
Condition:
Brand New
Write a review

Overview: Hex Hub for Wraith

This machined aluminum hex wheel hub is an aftermarket spare tailored to the Axial Racing Wraith and identified as AW-23025-GR. Presented in green, the hub swaps in for the stock piece and increases offset by 5mm to alter wheel placement without modifying axle parts.

Choose this hub when you need added track width or extra tyre clearance on challenging trail courses. The solid aluminum construction reduces flex versus molded hubs and helps keep wheel alignment consistent under load.

Installation is simple: remove the factory hub, move over any bearings or pins required, and fit the new hub with your existing wheel fixing hardware. Confirm wheel nut torque and run the suspension through its travel to check for clearance.

Does the machined aluminum hub last longer than the stock plastic part?

Machined aluminum is more resistant to deformation and wear under load, so you can expect improved longevity in aggressive trail use compared with molded hubs.

Will wheel bearings wear differently with this hub?

Bearing life depends on installation and sealing; the hub accepts standard bearings but do inspect fit and lubricate as recommended to avoid premature wear.

Any upkeep advice for aluminum hubs?

Check mounting hardware regularly for loosening, clean grit from contact areas, and re-torque wheel nuts after initial runs to preserve fitment and performance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved