Axial Racing Wraith Hex Hub Upgrade 3mm Offset AW-23024-BK by Jazrider  [AW-23024-BK]

Axial Racing Wraith Aluminum Hex. Wheel Hub / 3mm Wider (Black)
Price:
NZD$8.23
Brand:
JAZRIDER
Model:
AW-23024-BK
Condition:
Brand New
Write a review

Wider hex hub for tighter line control

Manufactured from machined aluminum, this hex wheel hub is specified for the Axial Racing Wraith and increases the mounting face by 3mm over the stock hub. It preserves axle geometry while expanding track width to help with obstacle clearance and finer steering inputs on technical terrain.

Key practical points:

  • Material and function: precision-machined aluminum holds form under load better than plastic, offering stable wheel mounting without excessive weight penalty.
  • Tuning role: the extra 3mm of offset widens track and can improve lateral grip; ideal when repositioning tyres for obstacle clearance.
  • Compatibility note: intended for Axial Racing Wraith chassis variants—check your wheel hex interface before purchase.
  • Installation tip: replace like-for-like, confirm seating on the axle hex and check wheel rotation for any runout after installation.

How well does the aluminum stand up to repeated rock strikes?

Machined aluminum resists compression and keeps the hex profile truer than plastic after impacts. Inspect for cracks or deformation after hard hits and replace if any damage is found.

Do I need different hardware when fitting this hub?

The hub uses the same mounting interface as stock hubs; use your existing hardware unless it is worn. Apply threadlocker where metal-to-metal fasteners are used for trail reliability.

Can I modify the hub for extra clearance?

Minor material removal is possible but not recommended unless you fully understand the impact on fitment. Altering hub geometry can cause misalignment or increased wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved