JAZRIDER YT-25001-BK Yeti Aluminum C Hub Carrier  [YT-25001-BK]

Axial Racing Yeti Aluminum C Hub Carrier (Black)
Price:
NZD$17.98
Brand:
JAZRIDER
Model:
YT-25001-BK
Condition:
Brand New
Write a review

Strengthen Your Axial Racing Yeti Front End

The JAZRIDER YT-25001-BK Aluminum C Hub Carrier is a practical upgrade to stiffen the front assembly of your Axial Racing Yeti. Machined aluminium offers consistent mounting points that reduce movement under load, which helps maintain steering accuracy on rough surfaces.

Why Choose Aluminium for Steering Components

Aluminium gives a good mix of strength and weight control compared with heavy steels or fragile plastics. The black anodised finish on the JAZRIDER YT-25001-BK also provides extra resistance to knocks and abrasion so the hubs keep performing session after session.

Installation Advice for Best Results

Fit the JAZRIDER YT-25001-BK using quality fasteners and check wheel runout after installation. Verify that the steering link geometry remains correct and make small adjustments if necessary to prevent binding at full lock.

Does this require special bearings?

No special bearings are required; standard hub bearings used on the Yeti fit as before, but check bearing seats for correct fit when swapping parts.

Will it change skid or ground clearance?

The carrier keeps the original mounting height, so ground clearance is essentially unchanged unless you alter wheel offset or tyre size.

Any maintenance tips to prolong life?

Keep fasteners tight, inspect for dents after heavy impacts, and clean the anodised finish to prevent grit from causing abrasion over time.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved