Axial Racing Yeti Rear Upper Link Aluminium Centre with Plastic Ends - YT014RP by GPM  [YT014RP]

Rear upper link in aluminium for Yeti

This rear upper chassis link is made for the Axial Racing Yeti platform and is supplied as 1pr. It features an aluminium centre section paired with plastic end fittings to interface with the stock link mounts on the chassis.

The component is a direct replacement for the rear upper link assembly and is intended to fine tune suspension geometry and handling. Fitting is straightforward: remove the stock links, move over any reusable hardware or bearings if needed, and mount the new links to the original points. No special adaptors are required for an unmodified Yeti.

For setup and care, verify link alignment and that the link moves freely throughout suspension travel, ensure end fittings are secure, and inspect attachment points for any looseness after initial runs. Standard RC hand tools will complete the job while keeping original torque values for chassis hardware.