Axial Racing Yeti Wheel Hex Spacer +5mm Delrin DYT010/+5MM by GPM  [DYT010/+5MM]

Axial Racing Yeti Delrin Hex Wideners (+5mm Thickness) - 2pcs set - GPM DYT010/+5MM
Price:
NZD$11.56
Brand:
GPM
Model:
DYT010/+5MM
GTIN:
4894538054750
Condition:
Brand New
Write a review

Delrin wheel hex spacer for Yeti

This pair of Delrin hex spacers fits Axial Racing Yeti wheel hex hubs and gives a +5mm offset to widen track. Supplied as a 2pcs set, they are sized to match standard Yeti hex hubs and deliver repeatable spacing for tuning adjustments.

They are ideal for reducing tyre rub and refining cornering on tight off-road layouts, where small changes to track width can influence balance and clearance. The text clearly positions the product as compatible with Yeti models, not as an OEM part.

Installation is a straightforward slip-on process: position the spacer on the wheel hex between hub and wheel, then secure the wheel nut while confirming proper thread engagement and a snug fit before driving.

Will these fit all Yeti versions?

They fit standard Yeti hex hubs used on common Yeti variants; check your hub face and hex size to confirm compatibility before purchase.

Do they change suspension geometry?

Adding track width shifts lateral load and can affect roll behaviour; pair with small incremental changes and test handling on-track to dial in the setup.

How do I check fit after installation?

After tightening, confirm wheel nut engagement, spin the wheel to check for clearance issues, and run a short test to ensure nothing loosens under use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved