Axial RR10 Bomber Rear Shock Mount Upgrade for Trail Use - RR030 by GPM  [RR030]

Rear shock mount in aluminium for RR10 Bomber

This item is an aluminium rear shock mount supplied as a 1pr set, intended as a direct replacement or upgrade for the Axial RR10 Bomber rear shock mounting point where the original geometry is retained. It is designed to interface cleanly with the Bomber's rear suspension layout and maintain factory fit where hole positions are unchanged.

Functionally the mount provides the structural attachment for rear shocks and passes loads into the chassis and shock tower. Fitting requires removing the rear end components and aligning the shock and tower mounting holes carefully; verify thread engagement and correct alignment before final tightening. No specific tool recommendations are given here.

For suspension tuning, switching to an aluminium rear mount can reduce flex at the mounting interface versus some plastic parts, which may influence shock angle and rear behaviour. Use it as part of controlled adjustments to rebound, spring rate, or shock position to dial in consistent rear-end performance on the RR10 Bomber.

The RR030 aluminium rear shock mount suits builders seeking a more rigid rear shock fixing and repeatable setup changes for the RR10 Bomber.