AXIAL SCX10 Front/Rear Drive Shaft Set F:123-133mm R:118-128mm SCX037SA by GPM  [SCX037SA]

Matched front and rear drive shafts for SCX10

This replacement kit provides a front and rear main drive shaft pair suitable for AXIAL Racing SCX10 models. Steel is used at the spline interfaces for wear resistance while aluminium sections help reduce rotating mass, and the kit is supplied as two pieces for the respective positions.

Length ranges fit common SCX10 drives, listed as front 123mm-133mm and rear 118mm-128mm. These shafts convey torque from the gearbox to the axle assemblies and affect driveline stiffness and endplay. Always confirm spline engagement and alignment during installation to prevent binding or accelerated wear.

Use this set when replacing worn shafts or when matching typical SCX10 front and rear lengths while keeping a steel/aluminium component mix in the drivetrain.