AXIAL SCX10 II Aluminum Rear Chassis Brace Upgrade - JR-AS210 by Jazrider  [JR-AS210]

Axial SCX10 II Aluminum Rear Frame Brace
Price:
NZD$11.98
Brand:
JAZRIDER
Model:
JR-AS210
Condition:
Brand New
Write a review
alt="Axial SCX10 II Aluminum Rear Frame Brace" title="Axial SCX10 II Aluminum Rear Frame Brace"
alt="Axial SCX10 II Aluminum Rear Frame Brace" title="Axial SCX10 II Aluminum Rear Frame Brace"
alt="Axial SCX10 II Aluminum Rear Frame Brace" title="Axial SCX10 II Aluminum Rear Frame Brace"

Rear Brace Fit and Purpose

This RC-scale rear frame brace is purpose-built for the AXIAL SCX10 II and manufactured by JAZRIDER as model JR-AS210. It installs as a direct replacement and concentrates on increasing rear-end rigidity while maintaining the stock mounting geometry.

Made from machined aluminum, the brace gives a firmer mounting surface for the rear chassis area. The added stiffness modifies how rear suspension and axle loads behave during slow-speed trail work and technical rock crawling, helping tuners achieve repeatable results.

Fitment uses the SCX10 II’s original frame mounting points; inspect clearances and hardware before final tightening. This item is intended for builders who actively adjust chassis flex and suspension balance, not for a purely cosmetic upgrade.

Do I need special tools to fit the brace?

No special tools are required; typical hobby hand tools will do. Check for any thin spacers or shims your variant may need before final assembly.

Will I have to modify my frame?

Major trimming is not normally necessary for standard SCX10 II frames, but verify clearances around body mounts and accessories prior to tightening.

Should I replace hardware when installing?

If the original hardware is worn or the fit is tight, upgrade to new screws or lock washers; otherwise standard fasteners usually suffice.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved