Axial SCX10 II and Traxxas TRX-4 Scale Front Bumper, Aluminum, LEDs & D-Rings JR-TRX443 by Jazrider  [JR-TRX443]

Aluminium scale bumper with lights and recovery points

This front bumper is an aluminum RC accessory designed for Traxxas TRX-4 and Axial SCX10 II chassis, featuring built-in LED lamps and recovery D-Rings. It serves as a protective and practical mounting platform for lights and light-duty recovery gear on scale trail builds.

Only the listed platforms are supported: Traxxas TRX-4 and Axial SCX10 II. The unit attaches to the chassis front mounting points and either replaces or supplements the stock bumper; check that your chassis mount pattern matches the bumper before installation. Typical hobby hand tools are adequate for the installation tasks described.

Fitting advice: remove the original bumper, align the aluminium bumper with the factory mount holes, fasten using the provided or equivalent hardware, and route LED wiring to an appropriate power source such as a switched lighting output or a small battery. Confirm LED polarity during setup and secure cables away from moving suspension and steering components. The D-Rings are intended for scale recovery and should not be used for full-size towing loads.

Effect on setup: the bumper provides a sturdy platform for lights and scale accessories but adds front mass that can slightly alter approach angles and weight distribution; minor suspension preload or shock setting changes can correct small handling differences for serious crawling sessions.

Choose this aluminium bumper when you want combined protection, integrated lighting and scale recovery points on TRX-4 or SCX10 II based crawlers, with straightforward installation and minimal tuning required.