Axial SCX10 II Replacement Transmission Shaft SCX27038SG by GPM  [SCX27038SG]

AXIAL Racing SCX10 II Steel Transmission Gear Shaft - 1set (For SCX10 90037, SCX10 Ii 90047, Smt10 90055, 90057) - GPM SCX27038SG
Price:
NZD$24.97
Brand:
GPM
Model:
SCX27038SG
GTIN:
4894538263596
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Steel Gear Shaft for Axial SCX10 II

This is a steel transmission gear shaft supplied as one set for Axial SCX10 II applications. It is produced to align with original fitment where compatibility is stated, so it can replace worn drivetrain shafts without altering your set up.

Fitment tips: remove the appropriate axle or gearbox cover on your SCX10, move over any original spacers or bearings, seat the new shaft properly and confirm correct gear mesh and bearing alignment prior to operation. The part functions as a mechanical drivetrain element for repair and tuning tasks.

Compatible Models

  • SCX10 90037
  • SCX10 Ii 90047
  • Smt10 90055
  • 90057

How do I confirm compatibility?

Match your chassis code to the listed models inside the compatibility box; if your code matches one of the four entries this shaft is intended to fit.

Should I reuse bearings from the old shaft?

Yes, transfer bearings and any spacers from the original shaft where they are in good condition, or replace bearings if they show wear to ensure correct alignment.

Any setup advice after replacement?

After installation, run a slow rotation check, listen for unusual noise and confirm that gear mesh and bearing seating remain consistent under light load.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved