AXIAL SCX10 III CVD Drive Shafts Front and Rear SCX3L037SA by GPM  [SCX3L037SA]

Durable CVD shafts for SCX10 III JT crawlers

This front and rear CVD drive shaft set is built for AXIAL Racing SCX10 III JEEP JT GLADIATOR vehicles, pairing 6061 T6 aluminium with steel elements to balance strength and scale weight. The swing joint CVDs preserve steady torque transfer while the suspension articulates on rocky lines.

Installation notes: designed to replace brittle dogbones or plastic drive pieces, these shafts mount to axle and transmission ends where CVDs are used. Check for axle hex clearance and secure the supplied screw pins. Use thread locker sparingly on metal screws and verify there is no contact through full suspension travel.

Tuning notes: upgrading to alloy/steel CVDs raises torque capacity and reduces driveline play, improving precision at crawl speeds. Also inspect splines, shims, and bearing condition as part of the upgrade process.

This GPM-produced CVD shaft kit is a practical upgrade for AXIAL SCX10 III JEEP JT GLADIATOR drivers seeking tougher driveline parts; test fit before finishing the build.